#How to install labview free trial manual#
If we were using one of the other SPI connections on the board say (SPI2), we'd have to look at the reference manual and see what channels are used for SPI2 (though if you look closely we have to use the DSPI library to use SPI2 which the LINX firmware does not use but that doesn't really matter right now).
![how to install labview free trial how to install labview free trial](https://www.yottavolt.com/wp-content/uploads/2019/10/lv-nxg-web.jpg)
In the case with the WF32, SPI0 uses channels 10-13 for the SPI data. SPI0 is the default SPI configuration for that board. This also has to do with question 3 where the SPI channel refers to the specific SPI configuration that you're using. So the pins that correspond to the SPI connections (CS, MOSI, MISO, and SCK) are determined by the board. The firmware will then be transferred to the WF32 and the on-board lights will flash.Īgain, if you're having trouble with these steps, check out the guide on LabVIEW MakerHub for step-by-step video instructions.ġ and 3. Click next and then choose LINX serial/USB and click next again. Choose the COM port that the WF32 is connected to. Choose Digilent from device family and choose chipKIT WF32 from device type and click next (pictured above). Now, launch LabVIEW and click tools -> MakerHub -> LINX -> LINX Firmware Wizard to deploy the LINX firmware to the chipKIT.
![how to install labview free trial how to install labview free trial](https://www.chiefdelphi.com/uploads/default/original/3X/4/7/47ff099cec2b7dbddf209e29993c1cb0efa56abe.jpeg)
Under the BM options, change the latency timer to 1 ms.
#How to install labview free trial drivers#
Once the drivers are installed, right click on the COM port for the chipKIT WF32 and click properties then click on port settings and choose advanced. If the drivers were not installed properly, download the drivers for your device which are included as part of MPIDE found at. The COM port is the chipKIT WF32 and if the drivers were not installed correctly, a yellow exclamation mark will appear over the device. To make sure, open the device manager from the control panel and expand the Ports section. Windows will most likely install the device drivers automatically. With all the required software installed, connect chipKIT WF32 to your PC using a USB A to mini B USB cable. A detailed installation instruction video can be found by clicking on "Getting Started." Once that is completed, install LabVIEW MakerHub LINX here by clicking on download now from the attached page. Next, install NI VISA here if you did not include it in your LabVIEW installation. If you have installed LabVIEW, chipKIT WF32 drivers, and LabVIEW MakerHub LINX already, you can skip this step.įirst, install LabVIEW onto your computer.